|
|
||
|
December 2000 |
|
Then, pry the breakers from the panel (Photo 5)
Carefully identify the neutral (white) and grounding wires (bare) from each circuit, loosen their binding screws and pull them free (Photo 6).
With all the wires disconnected, tape together each circuit's hot, neutral and ground wires (Photo 7).
|
Next, feed 10/4 cable through the pipe nipple (Photo 8). and strip the sheathing from both ends.
If you wish, you can use individual 10-ga. insulated wires coded red, black, white and green in place of the cable.
Connect the neutral and grounding wires to the main panel's neutral bus (Photo 9).
If your panel has a dedicated grounding bus, bind the grounding wire to the grounding bus and the neutral wire to the neutral bus. |
5
6
8
9